Junction Block Wiring on Fire Wall : There Is Three Wires 1993 CHEVROLET TRUCK; I do have ignition power to fuse box along with accessory power, just no permanent batt power! I do not have a wiring diagram but in supposition I think that the two wires that leave the convenience center are as follows. I medium thickness RED wire goes towards the passenger side and eventually terminates at a P0340 – Camshaft position (CMP) sensor A, bank 1 circuit Dec 09, 2020Faulty Sensor – If the sensor coil is open or shorted, then it will generate no signal. Go to All Data DIY or other source and get out your wiring diagram and DVOM (digital volt-ohm meter) I have a 2002 6 cylinder Chevrolet Trailblazer Ltz 4.2. So I might put the P0340 sensor problem in myself-1. SilveradoSierra • How To Repair GMC CK Series Trucks May 09, 2013Disclaimer: Any use of the information contained in this document is at the user’s own risk. The author does not assume any liability for actual or consequential damages. This Heater AC Control Unit was used on the 1996-98 line of Chevrolet and GMC C/K Pickups, and on 1996-99 GM Suburbans, Tahoes, and Yukons.
Related with 1996 chevrolet ignition coil wiring diagram