[PDF] Tutorial on ISO 10110 Optical Drawing Standard OPTI 521 The standards of most importance are: ISO 10110, Optics and optical Instruments – Preparation of optical drawings for optical elements and systems, is the primary reference for preparation of drawings for optical elements and systems. ISO 9211, Optical Coatings, is also very important. There is no American standard equivalent to ISO 9211. In Engineering drawing standards and unambiguous communication The standards follow the development in engineering. ISO 128 is an international standard (ISO), about the general principles of presentation in technical drawings, specifically the graphical representation of objects on technical drawings. ISO 1101 represents the initial basis and describes the required fundamentals for geometrical tolerancing.[PDF] Technical drawings — General principles of presentation ISO 10110-1:2006, Optics and photonics — Preparation of drawings for optical elements and systems — Part 1: General INTERNATIONAL STANDARD ISO 128-24:2014(E)[PDF] ENGINEERING DRAWING STANDARDS MANUAL This drawing standards manual establishes the conventions to be adhered to by engineering and drafting personnel in the preparation, revision, and completion of engineering drawings. This manual sets forth the minimum requirements acceptable at GSFC for the preparation of engineering drawings for flight hardware and ground support systems.
Related with engineering drawing standards iso 10110