GREDDY REMOTE SWITCHING SYSTEM OWNERS MANUAL
TECH SUPPORT - GReddy
Some GReddy / GPP products are designed and sold for sanctioned off-road/competition, non-emissions controlled vehicles only and may never be used on a public road or highway. Using these off-road GReddy/GPP products for street/road use on public roads or highways is prohibited by law unless a specific regulatory exemption exists.Profec Boost Control · Air Intake Systems · Oil Coolers · Intercoolers
GREDDY FULL AUTO TIMER INSTRUCTION MANUAL Pdf Download.
If you are missing parts please contact the GReddy Authorized Dealer you purchased the unit from. Turbo Timer Power Harness Main Harness 1pc. Page 3 4-pin connector of the Turbo Timer. Then connect the black wire with the loop connecter to a good chassis ground.( to steel body) key switch connector Optional GReddy Turbo Timer Harness (sold separately) key
GREDDY E-01 INSTRUCTION MANUAL Pdf Download.
• GReddy Pressure Sensor GReddy pressure sensor can be used for the scale of each Map table. This is used when the factory system exceeds the Air Flow Meter or MAP sensor capacity. Page 42 D e-manage Operation 1. Zoom Map screen in and out Press SET knob while holding down SHIFT button. Press SET knob while holding down SHIFT button. 2.
GREDDY E-MANAGE ULTIMATE INSTALLATION MANUAL Pdf
• Used with the Remote Switching System (sold separately) or Switching Harness (Sold separately). SERIAL • Used to link the GReddy Warning Meters with a Data Link Cable (sold separately) OPTION1,2 • Used to connect GReddy Pressure Sensor, GReddy Temp Sensor, and/or A/F Input Harness.
GReddy Miscellaneous Electronics Remote Switching System
Greddy 15500351 Remote Switching System. Can be used to turn on High/Low Boost settings, nitrous, and other switches. Compatible with the Profec boost controllers, e-Manage, Ultimate, and 5V/12V RSS adapter. Very simple to install. It mounts on to the steering wheel without dangling wires for easy access at the tip of your fingers.
Greddy Remote Switching System - INLINEFOUR
The Greddy Remote Switching System (RSS) allows the user hands-free modulation between high boost and low boost settings on any their PRofec boost controllers. It can also be used as a momentary switch for nitrous, line lock, etc., when used [PDF]
Instruction Manual - GReddy
Remote Switching System (sold separately) Back Line Switch Display TIME Button (Referred as "T") Used when switching the main modes. Used to change the countdown time and set-up time. SELECT Button (Referred as "S") Used when switching the sub modes. Used to start the stopwatch mode. POWER Button (Referred as "P") Turns the Turbo Timer "ON" or "OFF" [PDF]
Owner's Manual - Chevrolet
found later in this owner’s manual. Remote Keyless Entry (RKE) System The Remote Keyless Entry (RKE) transmitter may work up to 60m (197ft) away from the vehicle. Key Access with Remote Start Shown Press the key release button to extend the key blade. The key can be used for the ignition and all locks. Keyless Access with Remote Start Shown[PDF]
instruction manual 取扱説明書 Please read - GReddy
and fuel management systems. If installed by an untrained person, it may cause damage to the unit as well as the vehicle. Do not work on a vehicle that has recently been shut off. The exhaust system may be extremely hot and could cause burn injury. Professional installation is recommended. There is a risk of injury if performed by an untrained
GReddy Electronics - No Limit Motorsport
GReddy Remote Switching System allows the user hands-free modulation between high boost and low boost settings on either of our PRofec boost controllers. It can also be used as a momentary switch for nitrous, line lock, etc. Use our optional voltage adapters to wire it