MAC DHCP WITH MANUAL ADDRESS
Manual:IP/DHCP Relay - MikroTik Wiki
Property Description; add-relay-info (yes | no; Default: no): Adds DHCP relay agent information if enabled according to RFC 3046. Agent Circuit ID Sub-option contains mac address of an interface, Agent Remote ID Sub-option contains MAC address of the client from which request was received.
Manual:IPv6/DHCP Client - MikroTik Wiki
DHCP-client in RouterOS is capable of being a DHCPv6-client and DHCP-PD client. So it is able to get a prefix from DHCP-PD server as well as DHCPv6 stateful address from DHCPv6 server. Quick setup example. This simple example demonstrates how to enable dhcp client to receive IPv6 prefix and add it
Assigning a fixed IP address to a machine in a DHCP
Apr 05, 2018Start the server in DHCP. In the router panel, name it, basing on its mac address so that the router will remember it. 4. In the server switch IP from DHCP mode to manual and assign an IP that is beyond the ones that the router would assign to other devices (eg. 192.1).
Static and dynamic IP address configurations for DHCP
May 05, 2021MAC address - physical address encoded on the network interface card (NIC), used mainly by switches Hostnames are configured when the OS is installed, and MAC addresses are hard-coded on NICs. Sysadmins typically configure IP address information on servers, workstations, portable systems, and network devices.
[LAN] How to set up DHCP Server | Official Support | ASUS
Oct 08, 2020If you use a WINS server, please enter IP address of server. 8. If you want to manually assign IP for devices. Enable Manual Assignment, and then you can see device's name in MAC address. Choose the device you want to configure. 9. After choosing, you'll see the device's MAC address and its IP address, which is used now.
Networking: Check NTP Settings - SCS Computing Facilities
Windows 7 systems benefit from using the full set of NTP servers, but cannot be configured to obtain NTP server information from DHCP. Because the control panel does not allow setting multiple servers, settings on these systems must be verified and changed from a command prompt.